Feature

• Purpose

  Distortion takes, re-bending, paneling, deep drawing, piercing and If you attach Comb -shaped tool to bolster, you can use plate bending machine. Wide adaptability is a product.

• Rigidity of the machine

  Upper frame, Table below, Side frames, Bolsters, etc. are made of welded steel plate with sufficient strength to withstand the maximum load.

• High accuracy

  Parallel with high accuracy under the table surface and bottom bolster. Can be accurate forming, deep drawing, piercing, long sheet bending.

• Cylinder　Ram

  Ram has been processing of Hard chrome plating　or Polishing induction hardening. Less wear packing and oil leakage, can be used for a long time.

• Safety equipment

  Equipped with a safety device of Weight fall prevention device and Automatic stopping device on the top and bottom-stroke etc, It can be used safety.

Feature

• Giving a cross vibration, fluidize the powder of raw material.
• To equalize the density forming with degassing effect.
• Promote mutual pressure transmission of particles,　formed to the average density (20 to 50% of conventional) low-pressure forming.
• Roll forming in the thixotropic effect, has the effect of texturing.

Feature

• Excellent formability

  Use the electromagnetic proportional valve and servo valve, you can control the pressure and speed with high accuracy. Products will not crack even in high-speed forming.

• Special operation is possible

  Die Preceding, Punch preceding, Underfill, Overfill (Optional spec)

• You can adjust the thickness of the forming product. （Optional spec）

  Feedback the thickness of the forming product, and then adjust the thickness.

The main models

• Powder compacting with ceramic field、Powder compacting with metal field、Powder compacting with magnetic field

Feature

Slurry material is pressurized and dehydrated in a tool.

（Facilities content）

• Slurry tank （Equipped with a stirrer）
• Slurry injection machine（With Shutter valve, Check valve）
• Filter cloth, filter paper winding device
• Vacuum equipment
• Magnetic field power supply, coil magnetization
• Automatic eject device
• Tool die set

Feature

• Will be used to forming, heated of rubber and synthetic resin etc.
• The panel method of heating has steam heat and electric. We produce according to the application.
• To seal the tool in the vacuum case, you can also formed in the vacuum state.